Support Forum / Форум поддержки

My gearbox primary....

When I first ran this program, it showed upside down on my iPad 9th gen.

I always have my home button on the right side of my device, so I changed the SET ORIENTATION to 4 and that solved my problem.

What do I change so the "SLIDER VALUE" shows? Or isn't the value supposed to show?

If you touch and move the slider, the wheels start moving....
No values are shown.
Just play with these 2 sliders....

Thanks, I was doing that but saw the dashed lines (- -) below the sliders and wondered if the value was supposed to show at that location.

Okay, I just realized that the "- -" means minus (thus changing the rotation). I had only been moving the sliders from 0 to the top of the screen (+ +) and not down from 0.

Fun program! Well done!

What fascinates me is that the "in-between" wheels are not only rotating, but also moving, clockwise or counterclockwise, depending on the slider values....

To set the orientation 'left' or 'right', depending on the position of the device, you can program SET ORIENTATION HORIZONTAL.
However, this program is beautifully designed for multiple devices. If you program SET ORIENTATION ALL, it also works in a vertical position, at least as far as I can test with the iPad.
Well done

Ok. Now for all orientations and all (?) devices.....