A question about graphics

[Mr. Kibernetik]

Yes, this is the code: viewtopic.php?f=73&t=1933&p=11722#p11716
and what I get:

Снимок2.PNG (8.48 KiB) Viewed 4429 times

[Mr. Kibernetik]

Ok, in next release I will add experimental function to select DIP/PIXELS mode.
Experimental, because I cannot test it - on my computer they are the same (each DIP is 1 PIXEL). But you should see the difference, I think.

[rbytes]

I think that will be useful.

Here is a screen capture I made with the 10 points. On my tablet, SPL occupies the screen rather than a window, so I don't see "SPL". I can't remember if there is a way to change that.

To capture the full screen, I can just press Power/Volume Up, so that is what I did. I can also try Scissors if you think the result might be different.

Screenshot (24).png (29.69 KiB) Viewed 4429 times

[Mr. Kibernetik]

Aha, so on the tablet it is all a bit different, very interesting.
Thank you!

[Mr. Kibernetik]

Currently using DIPs we have this difference:

Снимок3.PNG (5.84 KiB) Viewed 4428 times

Interesting what we will get after #.point function is implemented, which will allow to select between DIP/PIX modes.

[rbytes]

I will also run this test on my Dell Inspiron laptop and post that.

[Mr. Kibernetik]

This is a code to be run in next version, which will be published soon.
New function #.point and constants #.dip and #.pix will be documented.

Code: Select all

mx,my=#.scrsize()'10
#.aaoff()
#.point(#.pix)'#.dip
> y, 0..my
  > x, y%2..mx,2
    #.drawpoint(x,y)
  <
<

[rbytes]

I have the new version. Here is my result of running the above code. I was surprised that the setting seems to make no difference on my tablet. I am still getting that antialiased look rather than a clean checkerboard of white and black pixels.

[Mr. Kibernetik]

Thank you for the test.
There are also some changes in version 0.0.15.
But I will be able to fix this issue when I use another computer and see this problem myself.